New equipment

HVAC Installation Wichita KS

Old system failing again or facing a big repair? Get a new system sized for your home so it runs evenly and doesn't cost more than it should.

AC, furnace and heat pump systems Load-based sizing Written, itemized quotes
A technician connects wiring on a new outdoor condenser beside a house.

Getting the size right

Air Conditioner Installation and Sizing

Air conditioner installation starts with sizing, and sizing should come from a load calculation (Manual J), not from the label on the old unit. An oversized air conditioner cools the house in short bursts, leaves it clammy and wears out sooner; an undersized one runs nonstop on the hottest days.

Homes in Wichita, KS cover a wide range of ages. The median house was built around 1974, so many systems are being installed into ductwork designed decades ago. Good HVAC installers check whether the existing ducts can carry the airflow the new equipment needs before quoting it. The same goes for heating and cooling installation of any kind.

If you'd rather keep the current system going, start with HVAC repairman help on our main page.

Call (316) 400-5244

Choosing equipment

Central Air, Furnace or Ductless?

✓

Central AC with a gas furnace

The most common setup here. Central AC installation alongside a furnace replacement keeps the indoor coil and outdoor unit matched.

✓

Heat pump with backup heat

Heats and cools with one outdoor unit and uses electric strips or a furnace for the coldest nights.

✓

Ductless mini split

Ductless heating and cooling systems fit additions, garages and rooms the ductwork doesn't reach, with no new ducts needed.

✓

High-efficiency gas furnace

Vents through PVC and drains condensate, so the install needs a drain route and new venting.

✓

Zoning and controls

Dampers and a zoned thermostat can even out a two-story house that's always hot upstairs.

✓

Duct changes

Undersized returns are a common reason new equipment underperforms. Fixing them is often part of a good install.

Call (316) 400-5244

Comparing quotes

Furnace Installers: What the Quote Should List

Furnace installers should give you a written quote that names the equipment model, the size in BTUs, the efficiency rating and everything included in the price. That makes it possible to compare two quotes fairly.

Look for the permit, venting changes, a new filter rack or return work, thermostat, startup testing and haul-away of the old equipment. In Wichita, Kansas, furnace and air conditioner replacements usually need a mechanical permit through the Metropolitan Area Building and Construction Department (MABCD).

Replacing a central air conditioner and gas furnace together typically costs about $6,000 to $11,000 here, depending on size, efficiency and duct work. Heat pump replacements typically run about $4,200 to $7,900.

A technician tests wiring on a newly installed furnace.
Startup testing should confirm gas pressure, temperature rise and airflow before the installer leaves.

Installed prices

How Much Does a New System Cost?

A new central air conditioner and gas furnace typically cost about $6,000 to $11,000 installed, and a heat pump replacement typically runs about $4,200 to $7,900. Equipment size, efficiency and duct changes drive the difference.

These are typical ranges, not quotes. Get at least two written quotes that list the same equipment and scope.

Call (316) 400-5244

Rooms ducts don't reach

Ductless Mini Split Installation

Ductless mini split installation is the practical fix for a finished garage, a sunroom, a bonus room over the garage or an addition that the main system was never sized for. An outdoor unit connects to one or more wall-mounted indoor heads through a small line set.

A mini split needs its own electrical circuit and a condensate drain for each indoor head. Ask where the line set will run outside so it can be covered and protected. Most AC installers who do central systems also install mini splits.

A technician points to a furnace while explaining it to a homeowner.

Facing a big repair on an old system? Price a replacement too.

Call (316) 400-5244

New system questions

New Equipment Questions

How much does HVAC installation cost in Wichita?+

A new central AC and gas furnace typically cost about $6,000 to $11,000 installed. A heat pump replacement typically runs about $4,200 to $7,900.

Do I need a permit to replace a furnace or AC in Wichita?+

Usually yes. Furnace and air conditioner replacements go through MABCD for a mechanical permit, so ask the installer whether the quote includes it.

Should I replace the furnace and air conditioner together?+

Often it makes sense, and AC replacement at the same time as a furnace can cost less than two separate jobs, since the indoor coil and outdoor unit need to match. If one is fairly new, ask whether replacing only the other will keep the system matched.

What size system does my house need?+

The right size comes from a load calculation based on the house, its windows and insulation, not from the old unit's size.

Can new equipment use my existing ductwork?+

Often yes, but older or undersized ducts can limit airflow. A good installer checks the ducts before quoting.

Plan the replacement

Call About a New System

Share the age of your current system and what's prompting the change. You'll talk with an experienced local contractor about sizing, options and a written quote.