Hot water trouble

Water Heater Repair Wichita

Cold showers or water pooling under the tank? Get the heater fixed or replaced before a small leak soaks the floor.

Gas and electric tanks Pilot, burner and element fixes Repair-or-replace pricing
A technician kneels beside a gas water heater and checks the control valve.

What goes wrong

Water Heater Repair for Gas and Electric Tanks

Water heater repair usually comes down to the heat source. On a gas tank, the common failures are a thermocouple or flame sensor, a pilot assembly, a gas control valve or a blocked burner. On an electric tank, it's usually a burned-out heating element or a failed thermostat.

Hard water makes both kinds work harder. Wichita, KS tap water is hard, at about 210 ppm (roughly 12 grains per gallon), so minerals settle to the bottom of the tank as sediment. That sediment is what makes a tank rumble or pop, and it insulates the burner or element from the water, which wastes energy and shortens tank life.

Many homeowners call a water heater repair plumber, but plenty of HVAC contractors fix gas and electric tanks too. Heating or cooling acting up too? Our main page covers affordable HVAC repair for the rest of the system.

Call (316) 400-5244

Symptoms

No Hot Water, Leaks or Rumbling?

✓

No hot water at all

On gas, check whether the pilot is out. On electric, check the breaker. If both are fine, a thermocouple, element or thermostat has likely failed.

✓

Hot water runs out fast

A failed lower element on an electric tank, a broken dip tube or heavy sediment can all shrink the amount of usable hot water.

✓

Rumbling or popping

That's water trapped under sediment flashing to steam. Flushing can help if the tank isn't too far gone.

✓

Water under the tank

A leaking relief valve or drain valve can be replaced. Water coming from the tank body itself usually means it's time to replace it.

✓

Rusty or smelly water

A worn anode rod can cause rusty or rotten-egg-smelling hot water. Replacing the rod can help an otherwise healthy tank.

✓

Pilot won't stay lit

A weak thermocouple or flame sensor is the usual cause and is a common, lower-cost repair.

Call (316) 400-5244

Replacement

Replacement Water Heater Options

A replacement water heater makes sense when the tank itself leaks, the unit is near the end of its life and needs an expensive part, or you're tired of running out of hot water. Replacing like-for-like (same fuel, same size, same location) is the simplest and least expensive route, and most water heater installers quote it that way first.

A standard tank replacement typically costs about $730 to $1,160 here. Moving to a larger tank, a tankless unit or a heat pump water heater can change the venting, gas line or electrical work, so ask for the full price, including any code updates, before you choose.

Gas water heaters need proper venting and a working relief valve. Ask whether the price includes a permit and haul-away of the old tank.

A technician checks the fittings on top of a water heater.
The tank, the fittings and the venting all get checked before choosing repair or replacement.

Tank repair pricing

How Much Is a Hot Water Fix?

Most water heater repairs typically cost about $220 to $730. When comparing water heater repair and replacement, thermocouples, elements and thermostats sit at the low end; gas control valves cost more.

These are typical ranges, not quotes. When a repair approaches half the cost of a new tank, it's worth pricing a replacement too.

Call (316) 400-5244

Make it last

Hard Water and Sediment

Flushing a tank once a year drains off the sediment that hard water leaves behind. On a tank that has never been flushed, a technician may advise against it, because loosened sediment can clog the drain valve.

An anode rod check every few years is the other inexpensive step. The rod corrodes instead of the tank; once it's gone, the tank starts to rust from the inside. In hard water areas like Wichita, Kansas, both steps of water heater maintenance help a tank reach its expected life.

Side-by-side photos of corroded tank fittings and clean new fittings.

Water pooling under the tank? Shut off the supply and call now.

Call (316) 400-5244

Hot water questions

Questions About Your Tank

How much does water heater repair cost in Wichita?+

Most water heater repairs typically cost about $220 to $730. A standard tank replacement typically costs about $730 to $1,160.

What should I do if my water heater is leaking?+

Turn off the cold water supply valve on top of the tank and turn off the gas or the breaker. Then call to have the leak checked.

Why does my water heater make a rumbling noise?+

Sediment from hard water collects on the bottom of the tank, and water trapped under it boils and pops. Flushing can help if the tank is still in good shape.

Is it worth repairing an old water heater?+

A low-cost part like a thermocouple or element is often worth fixing. A leaking tank body or a repair near half the cost of a new heater usually isn't.

Can a tankless water heater be repaired?+

Usually yes. Scale buildup, igniters and flow sensors are common fixes, and a yearly descaling helps prevent repeat calls in hard water.

Can a contractor replace a gas water heater with an electric one?+

Usually yes, but it may need a new circuit and a different location. Ask for the full price, including electrical work and permits.

Hot showers again

Call About Your Water Heater

Tell the contractor whether it's gas or electric, how old it is and what's happening. You'll get the repair and replacement options priced before any work starts.